User's Manual

7
6. The feeder will then try to connect to the Wi-Fi network. When
connected, Click Done to complete adding process.
If the feeder fails to connect, please check the important notice above
first.
If the feeder still fails to connect, please add the feeder via AP mode by
the following instructions below.
Add pet feeder via AP mode
1. If the feeder fails to connect to the Wi-Fi network, the AP mode is plan
B for adding the feeder.
Choose Switch Pairing Mode or choose AP mode manually in the
adding process.
Check that the indicator LED is flashing in RED once every 3 seconds.
Then click Indicator is flashing slowly.
If the indicator is in another status, please long press the Wi-Fi button
for 3 seconds until you hear a beep to switch indicator's flashing status
to flashing rapidly. Then long press the Wi-Fi button again to switch
indicator's flashing status to flashing slowly.