Users Manual

Module Drawing
Operation introduction
Download the Free App that release by JHin Apple Store or Google Play.
Turn on our WD8C25WiFi camera. The camera will take about 5 seconds to boot and
power on.
On your phone/tablet, turn on WiFi and search for the hotspotin the WLAN list. The
WiFi camera has a built in WiFi hotspot so no other WiFi network is needed.
NOTE: The camera will not link via Bluetooth – it is WiFi only.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
□Reorient or relocate the receiving antenna.
□Increase the separation between the equipment and receiver.
□Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
□Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement Caution: To maintain compliance
with the FCC’s RF exposure guidelines, place the product at least 20cm
from nearby persons