Specifications

Shenzhen Bigtree Technology Co.,Ltd

Step five: extruder stepper installation. Make sure you place the stepper

(1) with the correct orientation as highlighted with the red box. Four

threaded holes are facing the aluminum plate (2). Use then bag of

hardware labeled as A2 (black M3*10 bolt) (3). Tighten the stepper as

shown.

Step six: find the x-axis slider (1), use bag A3 hardware (black M4*8 bolt),

and tighten up extruder module (2).

Step seven: place the extruder wiring harness on the right, use the bolts

in bag A4 to secure the cable chain from left side (2) to right side (3), this

way is easier.