Owner's Manual

Wet Sounds WS-MC1 Media Center System Owner’s Manual

WS-MC-1 Basic Controls

LIGHTING Allows access to each lighting zone. The options are:

RENAME Allows a customized label (8 characters max) to be applied to each

zone. To change the characters, rotate the MCK until the desired letter or

number is displayed, then press the MCK to move to the next character and

repeat the process. Once the zone label is changed, press the MCK repeatedly

until all 8 characters have been changed (a blank space is available). Once the

zone is renamed, the MC-1 will conrm the action via the display. All zones are

capable of being renamed with a custom label.

ENABLE/DISABLE When a zone is disabled, it will no longer appear on the screen.

BLUETOOTH

Displays a list of Bluetooth

devices available for connection to the

MC-1. To connect, disconnect, or delete a displayed device, rotate the MCK until

the desired device is highlighted, then choose Connect, Disconnect, or Delete

using the buttons (6) below the display. Make sure the Bluetooth

on the device is

enabled (through the device’s settings). The MC-1 will conrm the action via

the display.

LEVEL ADJUST Allows individual volume level adjustment of the Bluetooth

audio and the auxiliary inputs. Ideally all input sources in a system are the same

volume level, but if not this adjustment might be needed if the output level of the

Bluetooth

audio or the auxiliary sources are louder than the other sources.

LABEL PRESETS Allows the 3 shortcut keys to have customized labels applied (up to

8 characters).

SHORTCUT KEYS Allows any source to be assigned to the 3 shortcut keys. Once in

the shortcut key mode, use the MCK to select from the available sources, then use

the buttons below the display to assign the sources to SC1, SC2, or SC3. After the

shortcut keys are set up, pressing these buttons will select the source set to that key.

LCD BRIGHTNESS Allows adjustment of the brightness of the display. Adjustment is

made by either rotating the MCK, or using the buttons (6) below the display.

CLOCK Making this selection allows the clock to be set. Adjustment is made by

either rotating the MCK, or using the buttons below the display.

DAY NIGHT MODE Allows the ability to scroll through the display options of DAY

(white screen/black characters) NIGHT (black screen/ white characters) or AUTO.

In AUTO mode, the display is in DAY mode until the vessel’s lights are turned on,

then the display goes into NIGHT mode. PLEASE NOTE: In order for the AUTO

function to operate properly, the ORANGE wire in the MC-BB harness labeled DIM

INPUT must be wired to a circuit in the vessel that gets +12V whenever the main

lighting switch is turned on.