User's Manual

Warning
CAUTION
1. The driver must not be able to view operational monitor while driving the
vehicle . This is illegal in most states. CHECK with your local law enforcement
officials for details .
2. Always check polarity when connecting wire to avoid damage to the unit and
/or vehicle.
3. Do not open the housing of the monitor ,Servicing must be done at our factory
by authorized technicians to maintain the warranty.
Specifications
System
Power Input/Consumption
Video Input
Operating Temperature
Storage Temperature
Screen Size(Diagonal)
Display Method
Resolution(Dot)
Back Light
Viewing Area
Viewing Angle
Monitor Overall Dimension
Monitor Weight
The Specifications are subject to change without prior notice
NTSC/PAL Auto Switch
DC(10.8~16V) 10% ,<700mA
Composite Video Signal 1Vp-p 75Ohm
-30 ~+85
-40 ~+65
7.0
TFT Active Matrix System
1440x234
CCFL
154.08(W)x86.58(H)mm
Left ,Right:65 Top:50 ,Down:65
182(W)x123(H)x23(D)mm
<1kg
CONNECT CABLE
DVD
AV box
V
L
R
EXTERNAL AV INPUT
V
L
R
DRIVER MONITOR AV OUTPUT
V
L
R
PASSENGER MONITOR AV OUTPUT
ANT
POWER
SPECIFICATIONS CONNECT CABLE
318
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help