User's Manual

4
/
12
④User manual (this document).
(2) Booster interface description:
①Manual gain control knob and LED light：You can manually rotate the knob to adjust the gain
of the corresponding frequency band .The corresponding LED on the right is used to indicate the
following different working conditions of the booster.
LED Indicator
Booster working conditions
LED LIGHT
Continuous GREEN @normal；
Twinkly GREEN @input signals may be not enough；
Continuous YELLOW @ stronger input signals, AGC is working；
Twinkly YELLOW@ self–oscillation happen ,AGC is working.
Continuous RED@ power supply is shut down；
Twinkly RED@ self–oscillation happen but power supply is NOT shut down.
②
Power supply jack:
The booster uses a power input range of DC 5-12V.
③INDOOR and OUTDOOR port：The two ports are used to connect outdoor and indoor
antennas.
(3)Antennas and Cables:
In order to use the Booster, you still need the corresponding indoor antenna 1pcs,
outdoor antenna 1pcs, outdoor cable 1pcs and indoor cable 1pcs.
Antennas and cables kitting information are as follows
Indoor Port
Power Supply Jack
Manual Gain Control Knob
LED Light
Outdoor Port
LCD