Instructions / Assembly

Page 6
STEP 10: SECURE YOUR COVER:
Fig. 13A, 13B, 14 & 15
Fig. 13B
corner leg
clamps
1013
1010
10023
Fig.14
middle leg
clamps
cross rails
12191
1013
10022
1010
Fig.15
Outside Corner View
Fig. 13A
Pull the cover over the frame so the webbing is at the front and rear
of the frame and the internal pipe pocket runs along the bottom of the
frame. Use the (4) ratchets as shown in Fig. 13A. Adjust the cover
so there is equal overhand on the front and rear. WIth the webbing
and ratchets, pull the cover snug but not tight. Remove the sliding
cross rails from the lower part of the frame by removing the bolts from
the half clamps, If the pipe pocket is not cut already, cut it about 2-3”
from each side of the rafter pipe. Insert the sliding pipe into the pipe
pocket and install half clamps again. When all of the pipes are
re-installed, push down ont he sliding pipe to tighten the cover over
the frame. When the cover is pulled tight, secure the clamps in
place. When all of the half clamps are secured tight, finish the (4)
ratchets to make the final adjustment to the cover.
Check and tighten
Ratchets and Cross
Rails monthly to
ensure the cover
is tight.
COVER TIGHTENING TIP
IS YOUR COVER
PULLED CORRECTLY
ON THE FRAME?
Fig. 13B
NOTE: ShelterLogic logo should line up on the left front and right rear corners near the top rail. If it is not legible and positioned
as shown above as “incorrect”, the cover has not been put on the frame correctly.
WARNING: Serious injury to persons or property could result if cover is installed and shelter is not completed and is left
unattended. Shelter must anchored down securely until completed.
CORRECT
INCORRECT