Instructions / Assembly

05-97053-OBPage 7
Step 9: Installing the Cover on the Frame
Fig. 12A
Fig. 12B
Fig. 12C
1. Lay the cover on the ground next to the frame
with the inside of the cover (the side with the pipe
pockets) facing down and the webbing on the front
and rear of the corner of the building. Position the
cover so that it is centered on the frame, front to
back. Fig 12A
2. Fold over the side closest to the frame so the pipe
pocket is now accessible. Insert a cover pipe at the
rst middle rib from the front and the rst middle rib
from the rear so that it is inserted in the pipe pocket
on both ends of the pipe but the center of the pipe is
exposed. For long buildings it may be necessary to
use additional pipes in the middle. Fig. 12B
3. Tie the rope on each of the exposed pipes and
throw the other end of the rope over the frame. Fig.
12C
4. Move to the other side of the frame and pull the
cover over the frame with the rope. This may re-
quire two or more people. Fig. 12D
Fig. 12D