Instructions / Assembly

05-97053-OBPage 8
Step 10: Secure your Cover
IS YOUR COVER
PULLED CORRECTLY
ON THE FRAME?
Fig. 13B
Pull the cover over the frame so the webbing is at the front and
rear of the frame and the internal pipe pocket runs along the
bottom of the frame. Use the (4) ratchets as shown in Fig. 13A.
Adjust the cover so there is equal overhand on the front and
rear. WIth the webbing and ratchets, pull the cover snug but not
tight.
Remove the sliding cross rails from the lower part of the frame
by removing the bolts from the half clamps, If the pipe pocket
is not cut already, cut it about 2-3” from each side of the rafter
pipe.
Insert the sliding pipe into the pipe pocket and install half clamps
again. When all of the pipes are re-installed, push down ont he
sliding pipe to tighten the cover over the frame.
When the cover is pulled tight, secure the clamps in place.
When all of the half clamps are secured tight, nish the (4)
ratchets to make the nal adjustment to the cover.
Outside Corner View
Fig. 13A
Fig. 13B
CORRECT
COVER TIGHTENING TIP
Check and tighten
Ratchets and Cross
Rails monthly to ensure
the cover is tight.
INCORRECT
Cross Rails
12191
1013
1010
10023
NOTE: ShelterLogic logo should line up on the left front and right rear corners near the top rail. If it is not legible
and positioned as shown above as “incorrect”, the cover has not been put on the frame correctly.
WARNING: Serious injury to persons or property could result if cover is installed and shelter is not completed and
is left unattended. Shelter must anchored down securely until completed.
Fig. 14
1013
10022
1010
clamps
middle
leg
corner
leg
clamps