Installation Guide

Page 6 05_GP-AA-XXXXXXA-015XXX12_C1
A. Connect the rst cross rail (#11103) to the front end rib and secure it with a 2 inch. bolt (#00648) as shown
in Fig. 7A. HAND-TIGHTEN this bolt.
B. Connect the middle cross rails (#11102) to the rst cross rail. Lay them over the top of the middle ribs and
connect using round head bolt (#11133). Fig. 7B.
C. Connect rail #11101 to complete the top cross rail. Connect to end rib with bolt #00648. Fig. 7A.
Top Cross Rail at End Rib
00648
00690
11136
Fig.7A
8. SQUARING UP THE FRAME
A. Be sure that frame in its nal location, which needs
to be as at and level as possible.
B. Measure across opposite corners.
These distances must be equal to within 1 inch.
C. Check that the front and rear of the frame
measures 15 feet, 6 inches in width.
15' 6"
Fig.8
11102
11103
11101
9. INSTALL AUGER ANCHORS
Fig.9
End RibMiddle Rib
7. INSTALL TOP CROSS RAIL
A. Anchors must be placed inside shelter at the corner
legs. Insert a ¾-inch pipe or steel rod through the eyelet
of the auger and turn the anchor clockwise until the
eyelet is sticking out of the ground 1 to 2 inches allowing
room to be anchored to the legs.
B. Thread cable provided through the eyelet of the Anchor
as indicated in gure 9. Secure the cable with the
clamps provided.
If the ground is too hard, dig a hole with a shovel or post
hole tool. Optional: Fill with cement.
If you are anchoring in gravel, clay, or asphalt,
ShelterLogic
®
recommends the Easy Hook
™
Drive
Anchors. Use one at each leg for a stronger, more
secure installation.
Fig.7B
Top Cross Rail OVER Middle Ribs
00690
11133
11101
11102
15' 6"