Installation Guide

Page 10 05_GP-AA-XXXXXXA-015XXX12_C1

COVER RAILS

11105

CORRECT

Webbing and Ratchets Securing Cover

FRONT

REAR

INCORRECT

Fig. 12

11130

11105

11106

00690

End Rib Cover Rail Clamps

11130

11105

11107

00690

Middle Rib Cover Rail Clamps

A. Make sure cover is centered on frame. There should be an equal amount of overhang at all four corners.

B. Insert the “S”- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet

and pull tight. Wind the ratchet so that the webbing overlaps itself.

C. Slide cover rails (#11105) through fabric pockets at each leg and reattach with clamps to each leg. Repeat

this on other side. Push down on cover rails to tighten cover, before tightening bolts completely.

D. Check and tighten Ratchets and Cover Rails monthly to ensure the cover is tight.

NOTE: The ShelterLogic

logo should

be oriented as shown below.

12. INSTALLING COVER AND COVER RAILS