Instructions / Assembly

Page 4

STEP 6: INSTALL WIND BRACES

Fig. 6

STEP 7: INSTALL TOP RAIL

Fig. 7

STEP 5: INSTALL SIDE RAILS AND

SHELTERLOCK™ STABILIZER BLOCKS

Fig. 5

Install the Top Rail

OVER all Middle Ribs

UNDER First & Last Ribs

Fig. 7

With help move the first end rib into the desired staked area. Place

the ShelterLock on the upright as shown in Fig. 5. From the outside

of the rib insert the bolt through the upright and then through the

ShelterLock. Place the plain end of the side rail over the bolt and

nest it into the ShelterLock. Install the nut onto the bolt and tighten.

Repeat these steps for the opposite side and all of the remaining ribs.

The side rails for the last rib will have two plain ends.

Take the wind brace and attach it between the end rib and the

first middle rib as shown in Fig. 6. Any attachments at the

cross rails should be made on the very inside of the cross rail.

Place the first top rail under the end rib and secure it with a bolt as shown in Fig. 7.

The same cross rail should lay on top of the first middle rib as with all of the middle

ribs. Secure the rails to the frame with the hardware indicated in Fig 7. The top rail

attached to the last rib will be installed under the pipe as the initial end rib.

Wind Brace

End Rib

Wind Brace

Fig. 6

Wind

Brace

Wind

Brace

11102

Fig.5

800454

800372

690

11102

669

11005-11179