Instructions / Assembly

ManualsBrandsShelterLogic ManualsStorage & Organization14 ft. W x 28 ft. L x 12 ft. H RoundTop Grey Garage

Basic Frame Assembly

STEP 2: ASSEMBLE END RIBS

Fig. 2

STEP 3: ASSEMBLE MIDDLE RIBS

Fig. 3

STEP 1: PLOTTING THE FRAME

Fig. 1

12'

Length

of Building

Before building your shelter, you should choose a flat area on your property and plot

your shelter.

1. Stake out the area for the shelter in the desired spot. The width of the area

should be at least equal to the width of the shelter and the length should be

equal to the length (“L”) of the shelter Fig. 1.

2. To be sure the staked area is square tie a rope diagonally from corner to corner.

3. Measure from where the two ropes intersect each other to all 4 corners. This

measurement should be the same. If they are not equal the stakes need to be

adjusted until the width, length and inside measurements are correct.

Assemble end ribs as shown in Fig. 2. Securely

fasten all of the joints with the hardware indicated.

Assemble all of the middle ribs as shown in Fig. 3. Securely fasten

all of the joints with the hardware indicated.

STEP 4: ASSEMBLE WIND BRACES

Fig. 4

Assemble all of the wind braces as

shown in Fig. 4. Securely fasten

the joints with the hardware

indicated.

Fig.1

Page 3

14'x28'x12' is the base frame dimension. Your model may have more middle ribs than shown in the illustration on pg.2. You will

receive one extra rib for every extra 4 ft. of building length that you purchase. The basic frame assembly will remain the same. The

cover will be the correct size for the length of the building.

NOTE: FRAME EXTENSION KIT

Fig.3

Fig.2

#11131

5/16"x2 3/4"

Bolts

11051

11112

11113

11114

#11131

5/16"x2 3/4"

Bolts

11051

11182

11113

11114

11182

Fig.4

11005 11179

use #648 5/16" x 2" Bolts