Installation Guide

05_GP-AA-XXXXXXA-028XXX20_H1Page 9
A. The anchors should be positioned at the four corners and the remaining should be spaced evenly on both
sides of the shelter.
B. Using the provided steel driving rod and a sledge hammer, drive each anchor into the ground leaving
approximately 8 inches of cable exposed above the surface.
C. Wrap the cable around the driving rod and pull up on the cable to set the anchor.
D. After the anchors are rmly set, wrap the cable around the foot, then close with a cable clamp. Be sure to
remove all slack from cable.
If the ground is too hard, dig a hole
with a shovel or post hole tool.
Optional: Fill with cement.
For best results, ShelterLogic
®
recommends using one Easy
Hook
™
Drive Anchor at each
leg for a stronger, more secure
installation.
9. INSTALL EASY-HOOK EARTH ANCHORS:
Fig.9
WARNING: Serious injury to persons or property
could result if cover is installed and shelter is not
completed and is left unattended. Shelter must
be securely anchored until completed.