Installation Guide

Page 12 05_GP-AA-XXXXXXA-028XXX16_G1
H. At the corners, insert the “S”- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle
of the ratchet and pull tight. Wind the ratchet so that the webbing overlaps itself. See Figure 11G.
I. Repeat these steps on the opposite side, then repeat this on the back side of the shelter.
J. Adjust the cover front to back so that it is centered. Install the bottom cover rails (#802051 and #802050) by
inserting them into the pipe pockets on each side of the cover. An opening allows the webbing to wrap around
cover rail and base rail to secure the cover. Tighten webbing using ratchet as shown in Figure 11J
K. Tighten all of the ratchets. Do this in an “X” pattern to be sure it is tightened evenly.
NOTE: CHECK THAT YOUR COVER IS CORRECTLY PLACED ON THE FRAME.
The ShelterLogic
®
logo should line up on the left front and right rear corners. If the logo does not read correctly, the cover
has not been put on the frame correctly.
Check and
tighten Ratchets
and Cross Rails
monthly to ensure
the cover is tight.
Cover Tightening Tip
TIGHTEN COVER DOWN
WITH RATCHET, STARTING
AT ONE END WORKING TO
OPPOSITE END ON BOTH
SIDES.
ASSEMBLED
COVER RAIL
11. INSTALLING THE COVER ON THE FRAME - continued
Thread
Webbing
Into
Ratchet
Fig.11G
Fig.11J
Fig.11I
Fig.11H
Webbing
and
Ratchets
Securing
Cover
CORRECT
INCORRECT