Product Manual

05_107153_0DPage 6

11130

11105

11107

00690

Middle Rib Cross Rail Clamps

10. INSTALL AUGER ANCHORS

Using a ¾-inch pipe or steel rod (a car tire iron works

also) placed through the eyelet of the auger; screw

the anchor into the ground. Start at the corners of the

shelter and space the remaining anchors evenly along

the length of the shelter. Screw the anchor into the

ground until the eyelet is sticking out of the ground by

1 to 2 inches so it can be anchored to the legs. Wrap

the cable provided through the eyelet of the anchor

and around the frame as indicated in Fig. 10. Secure

the cable with the clamp(s) provided.

Fig.10

End Rib AnchorsMiddle Rib Anchors

11105

8. SLIDING COVER RAIL ASSEMBLY:

A. Place a Cover Rail Pipe (11105) between each rib. Use 2 Rail

Clamps (11106 or 11107) to attach each end of the pipes.

B. Use Bolt #11130. HAND-TIGHTEN these bolts only!

NOTE: Round head of carrage bolts should be facing outside.

11130

11106

00690

11105

End Rib Cross Rail Clamps

9. SQUARING UP THE FRAME

A. Be sure that frame in its nal location, which needs

to be as at and level as possible.

B. Measure across opposite corners.

These distances must be equal to within 1 inch.

C. Check that the front and rear of the frame

measures 22 feet in width.

22 ft.

Fig.8

Fig.9