Product Manual

05_107153_0DPage 5
5. CONNECT RIBS WITH SIDE RAILS AND
SHELTERLOCK
™
STABILIZER BLOCKS:
A. Place assembled rst end rib in the staked area.
Place the ShelterLock
™
on the upright as shown in
Fig.5. From the outside of the rib insert the bolt through
the upright and then through the ShelterLock
™
.
B. Place the plain end of the side rail over the bolt and
nest it into the ShelterLock
™
. Install the nut onto the
bolt and tighten. Repeat these steps for the opposite
side and all of the remaining ribs. The side rails for the
last rib will have two plain ends.
NOTE: Connections that do not use a wind brace use a
4-1/8" bolt (800454).
800372
00690
800454
6. INSTALL WIND BRACES:
Attach wind brace between the end rib and the rst middle rib as
shown in Fig.6. Use 11134 Bolt.
Bolts attached at the cross rails should be inserted facing inside
the shelter.
Wind Brace
11095+800053+11093
11102
11102
11102
USE BOLT #11133
7. INSTALL TOP RAIL:
Place the rst top rail UNDER each end rib and secure it
with a bolt and nut.
The same cross rail should lay OVER all of the middle
ribs. Secure the rails to the frame with the hardware
indicated in Fig.7.
The top rail attached to the last rib will be installed
UNDER the rib.
Install the Top Rail
OVER all Middle Ribs
but UNDER End Ribs
11101
11102
Fig.5
Fig.6
Fig.7
800454
800372
00690
Wind Brace