Instructions / Assembly

ManualsBrandsShelterLogic ManualsStorage & Organization10 ft. x 16 ft. x 8 ft. Green Cover Round Style Shelter

05_101113_D4Page 6

A. Connect the rst cross rail (#10133) to the front end rib and secure it with bolt (#10115) as shown in Fig. 7A.

HAND-TIGHTEN this bolt.

B. Connect the middle cross rails (#02030) to the rst cross rail. Lay them over the top of the middle ribs and

connect using round head bolt (#00669). Fig. 7B.

C. Connect rail #10134 to complete the top cross rail. Connect to end rib with bolt #10115. Fig. 7A.

Top Cross Rail at End Rib

10115

01010

10121

Fig.7A

7. SQUARING UP THE FRAME

A. Be sure that frame in its nal location, which needs to

be as at and level as possible.

B. Measure across opposite corners.

These distances must be equal to within 1 inch.

C. Check that the front and rear of the frame measures

12 feet in width.

12 ft.

Fig.8

10133

10134

6. INSTALL TOP CROSS RAIL

Fig.7B

Top Cross Rail OVER Middle Ribs

01010

00669

02030

8. INSTALL AUGER ANCHORS

Fig.8

End RibMiddle Rib

A. Anchors must be placed inside shelter at the corner

legs. Insert a ¾-inch pipe or steel rod through the eyelet

of the auger and turn the anchor clockwise until the

eyelet is sticking out of the ground 1 to 2 inches allowing

room to be anchored to the legs.

B. Thread cable provided through the eyelet of the Anchor

as indicated in gure 9. Secure the cable with the

clamps provided.

If the ground is too hard, dig a hole with a shovel or post

hole tool. Optional: Fill with cement.

If you are anchoring in gravel, clay, or asphalt,

ShelterLogic

recommends the Easy Hook

™

Drive

Anchors. Use one at each leg for a stronger, more

secure installation.