Installation Guide

Page 8 05_GP-AA-XXXXXXA-015XXX12_C1

END PANEL VIEW

FROM INSIDE

SHELTER

D. At the bottom, where the webbing exits the pocket on each side of end panel, pull webbing as you would a

drawstring to remove the slack. Be careful not to pull the webbing strap out of the webbing pocket.

E. Insert the “S”- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet

and pull tight. Wind the ratchet so that the webbing overlaps itself. Position the end panel so that it is

centered on the building before fully tightening the end panel.

F. Tighten ratchets, alternating from one side to the other, until the end panel is tight. NOTE:

Keep Zippers

closed when tightening end panels.

WEBBING

STRAP

PULL PULL

10. DOOR PANEL INSTALLATION - continued

E F

Insert

Webbing

into

Ratchet

Webbing

and

Ratchet

Securing

End

Panel