Instructions / Assembly



ASSEMBLY OF ROUNDTOP
®
GARAGE SHELTER
05-201133_13-0D
05-201133_13-0D
NOTE FOR FRAME EXTENSION KIT: 12’ x 20’ x 8’ is the base frame dimension. Your model may have more
middle ribs than shown in the illustrations. You will receive one extra rib for every extra 4 feet of building length
that you purchase. The basic frame assembly will remain the same. The cover will be the correct size for the
length of the building ordered.
1. PLOTTING AND SQUARING UP THE FRAME:

on your property and plot your shelter. Stake out the area for

width and the length would be determined by the size shelter
you purchased. Tie a rope diagonally from corner to corner.
B. Measure across area, end to opposite end. See Detail A.
The measurement A and B should be equal.
12'
12'
A
B
LENGTH
OF
BUILDING
DETAIL A
2. ASSEMBLE END AND MIDDLE RIBS:
10224
10223
10225
10223
 
10224 10225
10223

10223

10224

10225

10224 10225
 
DETAIL B
End Ribs
DETAIL C
Middle Ribs

3-1/2” Bolt
2”
Bolt
#10210
3” Bolt
2”
Bolt
10' HIGH
8' HIGH

3-1/2” Bolt
2”
Bolt
#10210
3” Bolt
2”
Bolt
3. INSTALL SIDE RAILS AND SHELTERLOCK
™
STABILIZER BLOCKS:

ShelterLock
™

outside of the rib insert the bolt through the upright and then
through the ShelterLock
™
.
B. Place the plain end of the side rail over the bolt and nest
it into the ShelterLock
™
. Install the nut onto the bolt and
tighten. Repeat these steps for the opposite side and all of
the remaining ribs. The side rails for the last rib will have two
plain ends.
4. INSTALL WIND BRACES:

middle rib as shown in Detail E. Bolts attached at the
cross rails should be inserted facing inside the shelter.
5. INSTALL TOP RAIL:
end rib and secure it

lay on top of the all middle ribs. Secure the rails to the frame

to the last rib will be installed under the pipe.
10210
800260
01010
0
2
0
3
0
0
2
0
3
0
0
2
0
3
0
0
2
0
3
0
0
2
0
3
0
0
2
0
3
0
10205
10205
DETAIL D
DETAIL E
DETAIL F
FIRST
MIDDLE
RIB
WIND
BRACE
WIND
BRACE
END RIB
00669
10210
Install the Top Rail
OVER all Middle Ribs
UNDER First and Last Ribs
A. Assemble end and middle ribs as shown in Detail B and Detail C.
Securely fasten all of the joints with the hardware indicated.