Instructions / Assembly

Page 5Page 5
Page 4
05-10ET13-0A05-10ET13-0A
ASSEMBLY OF PEAK STYLE GARAGE SHELTER
NOTE FOR FRAME EXTENSION KIT: 10’ x 8’ is the base frame dimension. Your model may have more middle
ribs than shown in the illustrations. You will receive one extra rib for every extra 4 feet of building length that you
purchase. The basic frame assembly will remain the same. The cover will be the correct size for the length of the
building ordered.
1. PLOTTING AND SQUARING UP THE FRAME:
A. Before building your shelter, you should choose a at area
on your property and plot your shelter. Stake out the area for
the frame in the desired spot. Check that it measures 10’ in
width and the length would be determined by the size shelter
you purchased. Tie a rope diagonally from corner to corner.
B. Measure across area, end to opposite end. See Detail A.
The measurement A and B should be equal.
10'
10'
A
B
LENGTH
OF
BUILDING
DETAIL A
2. ASSEMBLE END AND MIDDLE RIBS:
DETAIL B
End Ribs
DETAIL C
Middle Ribs
#10114
2” Bolt
Item #19
All Connections
10' HIGH
8' HIGH
3. INSTALL SIDE RAILS AND SHELTERLOCK
™
STABILIZER BLOCKS:
A. Place assembled rst end rib in the staked area. Place the
ShelterLock
™
on the upright as shown in Detail D. From the
outside of the rib insert the bolt through the upright and then
through the ShelterLock
™
.
B. Place the plain end of the side rail over the bolt and nest
it into the ShelterLock
™
. Install the nut onto the bolt and
tighten. Repeat these steps for the opposite side and all of
the remaining ribs. The side rails for the last rib will have two
plain ends.
4. INSTALL WIND BRACES:
A. Attach wind brace between the end rib and the rst
middle rib as shown in Detail E. Bolts attached at the
cross rails should be inserted facing inside the shelter.
5. INSTALL TOP RAIL:
A. Place the rst top rail under each end rib and secure it
with a bolt as shown in Detail F. The same cross rail should
lay on top of the all middle ribs. Secure the rails to the frame
with the hardware indicated in Detail F. The top rail attached
to the last rib will be installed under the pipe.
DETAIL D
DETAIL E
DETAIL F
FIRST
MIDDLE
RIB
WIND BRACE
END RIB
00669
10210
Install the Top Rail
OVER all Middle Ribs
UNDER First and Last Ribs
A. Assemble end and middle ribs as shown in Detail B and Detail C.
Securely fasten all of the joints with the hardware indicated.
10121
10132
10132
10127
10127
10128
10128
10131
10132
10132
10126
10126
Fig. 2
800260
1010
10135
10135
800464
800464
800464
800464
10113
10113
10131
10132
10132
10126
10126
800464
800464
10113
10113
10223
10223
10132
10132
800464
800464
10223
10223
10128
10127
10127
10121
10128
#10114
2” Bolt
Item #19
All Connections
#10114
2” Bolt
Item #19
All Connections
#10114
2” Bolt
Item #19
All Connections
00670
02030
02030
02030
02030