Instructions / Assembly

Page 7
9. INSTALLING THE COVER ON THE FRAME:
A. Lay the cover on the ground next to the
frame with the inside of the cover (the side with
the pipe pockets) facing down and the webbing
on the front and rear of the corner of the build-
ing. Position the cover so that it is centered on
the frame, front to back. See Detail K.
B. Fold over the side so the pipe pocket is now
accessible. Insert a cover pipe into the pipe
pocket slot, at the rst middle rib from the front
and the rst middle rib from the rear. Some of
the pipe will be exposed. For long buildings it
may be necessary to use additional pipes in the
middle. See Detail L. Remove pocket pipe to
install later.
C. Tie the rope on each of the exposed pipes
and throw the other end of the rope over the
frame. See Detail M.
D. Move to the other side of the frame and pull
the cover over the frame with the rope. This
may require two or more people. See Detail N.
Check that the Logo reads upright as shown.
DETAIL K
DETAIL L
DETAIL M
DETAIL N
END PANELS
NOT SHOWN
FOR CLARITY