Full Product Manual

Page 6 05_GP-BA-XXXXXXA-012XXX08_G1
A. Connect the plain end of the rst cross rail (#02031) UNDER the front end rib and secure it with bolt
(#10210) as shown in Fig. 6A. HAND-TIGHTEN this bolt.
B. Connect the middle cross rails (#02030) to the rst cross rail. Lay them OVER the top of the middle ribs
and connect using round head bolt (#00669). Fig. 6B.
C. The last cross rail connects UNDER the end rib with bolt #10210. Fig. 6A. HAND-TIGHTEN this bolt.
Top Cross Rail UNDER End Rib
10210
01010
Fig.6
02031
6. INSTALL TOP CROSS RAIL
Fig.6B
Top Cross Rail OVER Middle Ribs
01010
00669
02030
02030
02030
02031
7. SQUARING UP THE FRAME
A. Be sure that frame in its nal location, which needs
to be as at and level as possible.
B. Measure across opposite corners.
These distances must be equal to within 1 inch.
C. Check that the front and rear of the frame
measures 11 feet 6 inches in width.
11' 6"
Fig.7
8. INSTALL AUGER ANCHORS
Fig.8
End RibMiddle Rib
A. Anchors must be placed inside shelter at the corner
legs. Insert a ¾-inch pipe or steel rod through the eyelet
of the auger and turn the anchor clockwise until the
eyelet is sticking out of the ground 1 to 2 inches allowing
room to be anchored to the legs.
B. Thread cable provided through the eyelet of the Anchor
as indicated in gure 9. Secure the cable with the
clamps provided.
If the ground is too hard, dig a hole with a shovel or post
hole tool. Optional: Fill with cement.
If you are anchoring in gravel, clay, or asphalt,
ShelterLogic
®
recommends the Easy Hook
™
Drive
Anchors. Use one at each leg for a stronger, more
secure installation.
11' 6"