Full Product Manual

Page 4 05_GP-BA-XXXXXXA-012XXX08_G1

NOTE: FRAME EXTENSION KIT

12'x20'x8' is the BASE frame dimension. Your model may have more middle ribs than shown in the illustration on

page 3. You will receive one extra rib for every extra 4 ft. of building length that you purchase. The basic frame

assembly will remain the same. The cover will be the correct size for the length of the building you purchased.

2. ASSEMBLE END RIBS

3. ASSEMBLE MIDDLE RIBS

Assemble end ribs as shown in Fig. 2. Securely

fasten all of the joints with the hardware indicated.

Assemble middle ribs as shown in Fig. 3. Securely

fasten all of the joints with the hardware indicated.

BUILDING

LENGTH

11' 6"

WIDTH

Fig.1

1. PLOTTING THE FRAME:

Before building your shelter, you should choose a at area on

your property and plot your shelter.

A. Stake out the area for the shelter in the desired spot. The width of

the area should be at least equal to the width of the shelter and the

length should be equal to the length of the shelter Fig. 1.

B. Measure diagonally from corner to corner (A & B). These

measurements should be the same. If they are not equal the stakes

need to be adjusted until the width, length and inside measurements

are correct.

Fig.2

Fig.3

10224

10226

10273 10273

10226

10225

10210 - 3" Bolt

10114 - 2" Bolt

10225

NOTE:

HAND-TIGHTEN the 3" Bolt (# 10210) at the top.

10270