Quick Clamp Canopy Owner's manual

ManualsBrandsShelterLogic ManualsSports and recreation14553 7 4 x 10

05-14553-0APage 1

ShadeLogic

™

Quick Clamp Canopy Tilt-Mount

™

Table Top Pop Up

Assembly Instructions

150 Callender Road

Watertown, CT 06795

www.shelterlogic.com

1-800-524-9970

1-800-559-6175

Canada:

12/07/09

DESCRIPTION MODEL #

7'4" x 10' Quick Clamp Canopy

™

14553

Before you start: 2+ individual recommended for assembly, approximate time 15 min.

Please read instructions COMPLETELY before assembly.

THIS IS A TEMPORARY STRUCTURE AND NOT RECOMMENDED AS A PERMANENT STRUCTURE.

FITS ANY TABLE UP TO 10'

Table NoT INcluded

WARNING

KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC

This canopy meets the ammability requirements

of CPAI-84. It is not re proof. The fabric may

burn if left in continuous contact with any ame

source. The application of any foreign substance

to the tent fabric may render the ame resistant

properties ineffective.

Summary of content (5 pages)

PAGE 1
ShadeLogic ™ Quick Clamp Canopy Tilt-Mount™ Table Top Pop Up Assembly Instructions Fits Any Table up to 10' Table Not Included Description 7'4" x 10' Quick Clamp Canopy™ Model # 14553 Please read instructions COMPLETELY before assembly. THIS IS A TEMPORARY STRUCTURE AND NOT RECOMMENDED AS A PERMANENT STRUCTURE. Before you start: 2+ individual recommended for assembly, approximate time 15 min.
PAGE 2
ATTENTION: This Shade/Canopy product is made with the highest quality material available. ShelterLogic™ Quick Clamp Canopy offers protection from sun, light rain, tree sap, animal bird excrement and light snow. Quick Clamp Canopy™ is designed to fit most tables or bleachers made of wood, hard resin plastic, aluminum, steel, or thick pressboard up to 10’ wide. DO NOT INSTALL PRODUCT TO GLASS TOP TABLES, LIGHT SMALL TABLES, OR BREAKABLE SURFACES.
PAGE 3
1. ATTACH QUICK CLAMP BRACKETS, 1 ON EACH SIDE 802788 2. INSERT FRAME UPRIGHTS INTO QUICK CLAMP BRACKETS 802786 802788 802787 3.
PAGE 4
. INSERT BOTTOM CROSS RAILS: 802786 802787 802787 5. PULL COVER OVER FRAME AND SECURE: Pull cover over frame. Fasten corners of cover and top rail. Corner Hook & Loop Fasteners 6. LIFT COVER ARMS TO UPRIGHT POSITION Extend the frame to the fully open position. Insert the side poles into pockets created by the hook and loop fasteners on each side. Push tightly together along cover edge so cover is very tight.
PAGE 5
7. ADJUSTING YOUR TILT-MOUNT CANOPY A. Adjusting the angle of the base: Lift handle to release the upright and move to desired position. Push handle down to lock the upright in place. CAUTION: Do not force handle B. Adjusting height of the canopy: Push pop-pin in and slide the upright to the desired position.