Instructions / Assembly

05_26773_0GPage 4

10045

10046

802106

10162

10161

10047

10048

10047

10161

802104

802106

10046

10045

2. LAY OUT ROOF FRAME

• Assembly is easiest if you lay out the roof parts as shown in the location you intend to erect the shelter.

• Start by assembling the center peak then assemble each side.

• All connections use 2

inch (# 10017) bolts, EXCEPT where noted ( ) use 2

inch (# 10114) bolts.

NOTE:

Install all carriage bolts with the nut toward the center of the frame.

1. PLOT THE LOCATION

18 ft. W

20 ft. L

Before building your canopy, choose a at area and plot your location.

A. With enclosed Spikes (10431), stake out the area for the canopy in the desired

spot. The width (W) of the area should be at least equal to the width of the

canopy (18 FT.) and the length should be at least equal to the length (L) - 20 FT.

B. To be sure the staked area is square, tie a rope diagonally from corner to corner.

C. Measure from where the two ropes intersect each other to all 4 corners. These

measurements (A and B) should be the same. If they are not equal the spikes

need to be adjusted until the width, length and inside measurements are correct.