Product Manual

05_10072_0APage 3
1. PLACE COVER AND SECURE TO CANOPY FRAME
A. Place cover over assembled roof frame with grommet panels facing down, aligned with cross rails.
B. Make sure the cover is properly aligned on the frame, secure the four corners of the cover with bungees
(10066) to the frame rst. Attach remaining bungees.
Re-adjust bungees position along cross pole as needed to ensure a tight and even t of the cover to the frame.
2. TIGHTEN THE COVER WITH TWIST TITE
™
Twist-Tite
™
Tighten Cover
Grommet Panels for Bungees
Grommet
Panel
10066
cover
Secure Bungee Around Plastic Ball
Insert Bungee Cord Through Grommet Hole
A. Wrap the cover's cord with plastic ball and "S" hook at the
corners of the cover around the corner leg poles. Insert "S" hook
into the hole of the corner leg poles.
Twist each leg pole toward the inside of the shelter until the cover
becomes tight. Twist the leg poles equally to ensure the cover
stays aligned during tightening.
B. To keep the leg in place, wrap a TwistTite
™ cord around the
cross rail and insert its "S" hook into the lined-up hole of the
leg pole and 3-way connector. This will prevent the leg from
"untwisting". Do this at each corner.
Grommet Panels for Bungees
Grommet Panel
cover
10047