Specifications
57
Phone
800-236-0112
FAX
800-444-0331
www.tapconet.com
DoorKing
®
Swing Gate Operators, 3 Button Gate Control Station, Loop Detector and Accessories
LMA-1250 Inductive Loop Vehicle
Detectors
Single channel
Dual programmable relay outputs
Automatic tuning
Lightning & surge protection
Four (4) frequency levels
Compatible with all radio controls and remote
openers
Sensitivity boost
Fail safe and fail secure configurations
Separate color-coded led indicators
Wide loop inductance range: 20 to 2500 microhenries
LMA-1250-LV operates on 12VDC, 24VDC and 24VAC
395-00011
$114
LMA-1250-HV operates on 120VAC and 240VAC
395-00010
Paveover Style Preformed Vehicle
Detection Loop Flexible Conduit
Completely assembled and ready to set in place
for paving, concrete pour, gravel roadways
or brick pavers. By eliminating saw cutting
and costly sealant, installation is cut by hours.
The watertight conduit protects the loop turns from being damaged
by sharp stones, heaving, chemicals and the elements. The watertight
sealed lead-in connection insures a flawless operation. Easily shipped,
the design and material allow this loop to be coiled and packed in a
small carton.
Loop Wire: 18GA PVC Insulation and Final Jacket Type C
Lead-In 18GA twisted pair, 19 strand XLP insulated conduit. Flexible
non-metallic ½" watertight conduit
"T" Standard schedule 40 ½" PVC type T fitting. Watertight seal. Accepts
standard ½" non-metallic conduit for lead-in protection.
Loop, pave over, 2 .5 ' X 6' with 20' lead in 105310
$125
Loop, pave over 4' x 8' with 75' lead in 106104
$165
Loop, pave over 6' x 20' with 50' lead in 106837
$209
Loop, pave over 6' x 30' with 50' lead in 106838
$299
Bondo
®
P-606 Flexible Loop Sealant
Highly durable and remains permanently flexible. This
loop sealant can withstand the corrosive effect of road
salts, automotive fluids, jet fuel, gasoline and extreme
weather conditions. It also features rapid chemical
curing, which minimizes the length a lane is closed and
has extreme adhesion to concrete and asphalt. This loop
sealant can also be color tinted.
Bondo P-606 flexible sealant, 1 gallon 016-00002
$35
Bondo P-606 flexible sealant, 4.5 gallons 016-00008
$149
6100 and 6300 Swing Gate Operators
Convenience, reliability and quiet operation in an
aesthetically pleasing design. The unique design
of these operators allow the gate arm to rotate
from underneath the operator allowing the gate
arm to attach to the bottom rail of the gate, where
it is virtually unseen from outside the gate. This
design allows the operator to be fully enclosed and
prevents water from contaminating the output
shaft, bearings and electronics. Additionally,
the frame is built from G90 galvanized steel
to prevent rusting. These operators can be
installed directly on a concrete pad, or they
can be post mounted to meet any installation
requirements. Designed with safety in mind,
these operators feature an electronic and
mechanical inherent reverse system providing
you with peace of mind. The automatic
electronic limits precisely control the travel
of your gate, never need adjustment and will
never wear out or break.
½ horsepower, 115 Volt for up to
30' gates, (up to 1000 lbs.)
Quiet operation
Weather proof design
Electronic and mechanical
inherent reverse design
Automatic electronic limits (gate
travel) never needs adjustment
Power and alarm reset switches
2 piece articulating arm for slow
start / stop
Overlap feature for bi-parting
dual gate application
Gate tracker reporting output
Magnetic gate lock output
Tamper protect feature
Ports for plug-in open and
reverse loop detectors (DKS only)
Keyed release for manual
operation
Clutch can be back-driver for fail
safe operation
6100 swing gate operator, ½ HP, 115v, primary, 14' (500 lb. gate max)
108635
$2,220
6100 swing gate operator, ½ HP, secondary, 14' (500 lb. gate max)
108636
$1,690
Pad mount, gate arms and hardware for 108635 and/or 108636
108641
$440
Post mount, gate arms and hardware for 108635 and/or 108636
108642
$360
6300 swing gate operator, 1 HP, 115v, primary, 22' (800 lb. gate max)
108637
$2,990
6300 swing gate operator, 1 HP, 230v, primary, 22' (800 lb. gate max)
108639
$3,420
6300 swing gate operator, 1 HP, 460v, primary, 22' (800 lb. gate max)
108640
$3,420
6300 swing gate operator, 1 HP, secondary, 22' (800 lb. gate max)
108638
$2,460
Pad mount, gate arms and hardware for 6300 swing gate operators
108643
$562
Post mount, gate arms and hardware for 6300 swing gate operators
108644
$562
3 Button Gate Control Station
Designed to mount into a single-gang electrical box.
Unique logic inputs require only 3 wires for connection to
a 3 button control station. Controls a single gate only.
3 buttons: Open – Close – Stop
Ideal for exterior application (can be used indoors)
Operates with DoorKing
®
gate operators only
Can be surface or post mounted
7.75" H x 5.875" W x 3" D
Operating Temperature -10˚F to 145˚F (-23˚C to 62˚C)
Push button station for DoorKing
®
gate operators
1501-00002
$125
395-00011
On site installation of all TAPCO systems is available in
specific areas of the United States. Please call or email
info@TAPCOnet.com for an installation quote.