Owner`s manual

22
Problem: Home does not achieve comfortable temperature.
• Improper ductwork connection to
existing furnace.
• Refer to information in the manual relating to the proper installation
procedures or contact your local heating and cooling contractor.
Possible Causes:
Remedies:
• Improperly sized ducting.
• Refer to information in the manual relating to the proper ducting
procedures or consult your local heating and cooling contractor.
• Check and replace lter. Proper lter size is 20” by 25” by 1.”
• Furnace room may be too airtight. Install an aperature to the outside
consisting of a minimum of 12 square inches or 4 inches round.
• Consult a professional to determine correct sizing.
• Excessive dirt accumulation in
air lter.
• Combustion chamber not
receiving an adequate amount
of oxygen.
• Furnace size is inadequate for
your home.
12.
• Completely avoid using if at all possible. If circumstances
necessitate the use of wet or unseasoned wood, then fuel the
furnace with smaller loads.
• Fueling furnace with wet or
unseasoned wood.