Owner`s manual

DANGER: RISK OF FIRE OR EXPLOSION – do not burn garbage, gasoline, naphtha, engine oil, or other ammable liquids/inappropriate

materials.

Supplemental Outside Combustion air may be necessary if:

• the solid-fuel-red appliance does not draw steadily, smells, experiences smoke rollout, burns poorly, or back-drafts

whether or not there is combustion present. Opening a window slightly on a calm day may alleviate these symptoms.

• the house is equipped with a well-sealed vapor barrier and tight tting windows, and/or has any powered devices

which exhaust house air.

• there is excessive condensation on windows in the winter.

• a ventilation system is installed in the house.

BURN WOOD AND COAL ONLY!

First Wood Fire:

Check to make sure the spin draft is wide open to allow oxygen into the rebox. Make sure the Draft Control is in the start position.

Place several crumpled newspapers on the grate with some dry kindling layered on top of the papers, then ignite the newspaper. When

the kindling is burning, add several small pieces of wood, allow wood to fully ignite. After about 20 minutes the re should be established,

allowing you to add more wood – do not overload which would smother the re. Add more wood slowly, so the ames have time to engulf

the fresh wood. Once the re is burning and there is a glowing ember bed, adjust the draft to achieve desired burn pattern. Learning how

to adjust the draft to maintain the desired temperature for your home may take several days. After a short time you will know which settings

and adjustments work best for your home.

Do not over-re the furnace. Over-ring by overloading/over fueling the furnace causes the metal to superheat and expand, then cool

rapidly, which causes cracking, therefore voiding the warranty. Over-ring or abuse can easily be determined upon inspection.

It will take about 40 minutes to establish a bed of hot embers. Once you have achieved the hot ember bed, add larger pieces of rewood.

Within 30 to 40 minutes, adjust the spin draft to obtain optimum performance.

NOTE: Your new Shelter Furnace is capable of producing a very high BTU output. Do not fuel your furnace to capacity upon initial ring.

It’s recommended that you become thoroughly familiar with your Shelter Furnace before operating at full capacity.

The new steel and metal components of the furnace have a protective coating or paint on the surface which could produce an odor during

OPEN