Instructions

4
Installation Instructions
CAUTION! Danger of electrocution. Even when the device is turned off, it is
possible to have voltage across its clamps. Never disconnect or reconnect
the clamps before ensuring all local power is disconnected.
CAUTION! Do not connect the Device to appliances exceeding the given
max load!
CAUTION! Connect the Device only in the way shown in this instructions.
Any other method could cause damage and/or injury.
CAUTION! Before beginning the installation please read the accompanying
documentation carefully and completely. Failure to follow recommended
procedures could lead to malfunction, danger to your life or violation of the law.
Allterco Robotics is not responsible for any loss or damage in case of incorrect in
-
stallation or operation of this device.
CAUTION! Use the Device only with power grid and appliances which com-
ply with all applicable regulations. Short circuit in the power grid or any
appliance connected to the Device may damage the Device.
RECOMMENDATION: The Device may be connected to and may control
electric circuits and appliances only if they comply with the respective
standards and safety norms.
Initial Inclusion
Plug the Shelly to the power socket without any device / load connected to the
Shelly.
Press the Power Button. The Button should turn red. This means that Shelly has
turned on the socket and it may provide power to an appliance or device. Press the
Button again and the red light will turn off. This means that Shelly’s socket is no
longer supplying power.
You may choose if you want to use Shelly with the Shelly Cloud mobile application
and Shelly Cloud service. You can also familiarize yourself with the instructions for
Management and Control through the embedded Web interface.
Factory Reset
You can return your Shelly Plug to its Factory Settings by pressing and holding the
Power Button for 10 seconds.
Upon successful factory reset Shelly’s WiFi LED will turn Blue.