Instructions
14
Settings – General Settings
In this menu, you can congure the Shelly device’s
work and connection modes.
WiFi Settings – the WiFi connection settings.
Access Point (AP) Mode: Allows the device to op
-
erate as a WiFi access point. The User can change
the name (SSID) and the password to access the
WiFi. After you have entered the desired settings,
press Connect.
WiFi Client Mode (CM): Allows the device to
connect to an available WiFi network. In order to
switch to this mode, the User must enter the name
(SSID) and the password to connect to a local WiFi
network. After entering the correct details, press
Connect.
ATTENTION! If you have entered incorrect infor
-
mation (wrong settings, usernames, passwords
etc.) you will not be able to connect to Shelly.
WARNING: To reset the device, press and hold the Power Button for at least
10 seconds. Watch at the color of the Button. After the Button begins to
blink fast in red, release it.
Login: Access to the Device
Leave Unprotected - removing the notication for disabled authorization.
Set Login – you can turn authentication on or off
Username - A username set by you
Password - A password set by you
This is where you can change your username and password. You must enter a new
username and the new password, then press Save to save the changes.
Connect to Cloud: You can turn the connection between Shelly and Shelly Cloud
on or off.
Max Power: You can limit the maximum power the socket will supply. If the pre-set
current draw is exceeded, Shelly will turn the socket off. Allowable power can be
set up to 3500W.
Factory reset: Return Shelly to its factory settings.