Instructions

13
The Embedded Web
Interface
Еven without the mobile app the Shelly
Device can be set and controlled through
a browser and WiFi connection of a mobile
phone, tablet or PC.
ABBREVIATIONS USED:
Shelly-ID – the unique name of the Device.
It consists of 6 or more characters. It may
include numbers and letters, for example
35FA58.
SSID – the name of the WiFi network,
created by the Device, for example
shellys4pro-35FA58.
Access Point (AP) – the mode in which
the Device creates its own WiFi connection
point with the respective name (SSID).
Client Mode (CM) – the mode in which
the Device is connected to another WiFi
network.
Installation/Initial inclusion
Step 1
Connect Shelly to the power grid following
the schemes described above and place it
into the console. After turning the power on
Shelly will create its own WiFi network (AP).
WARNING: In case the Device has
not created its own WiFi network
with SSID like shellys4pro-35FA58 check if
you have connected Shelly correctly by the
schemes described above. If you don’t see
active WiFi network with SSID like
shellys4pro-35FA58 restart the Device by
the ways above.
Step 2
When Shelly has created an own WiFi
network (own AP), with name (SSID) such
as: shellys4pro-35FA58.
Connect to it with your phone, tablet or PC.
Step 3
Type 192.168.33.1 into the address field of
your browser to load the web interface of the
Shelly Device.
General - Home Page
This is the home page of the embedded web
interface. If it has been set up is correctly, you
will see information about:
• Current electrical consumption
• Settings menu button
• Current state (on/off)
• Present time