Installation Instructions

Installation Instructions
Semicircle Glass Shelf Kit
KT-0134-812SN
Tools Required (not included):
- Power Drill
- 1/8" Drill Bit or 3/16" Drill Bit
- Screwdriver
- Tape Measure
- Level
Installation Materials (included):
- (1) Semicircle Glass Shelf
- (2) Shelf Grips
- Mounting Hardware
Load Rating:
- 25 lbs when mounted onto studs
Installation:
STEP 1: Loosen the adjusting screw on the Shelf Grip until the inner hole appears, as
shown in Figure 1. Repeat for the other Shelf Grip.
STEP 2: Draw a line on the wall, using the level, in order to determine where the screw
holes will be located. The screws should be installed approximately 8" apart, as shown
in Figure 2.
NOTE: If the screws are being driven directly into a stud, pre-drill the screw holes
using a 1/8" drill bit, as shown in Figure 3. (Skip to STEP 3)
NOTE: If the screws are being driven into drywall and not into a stud, drill the screw
holes using a 3/16" drill bit. Then insert the anchors into the holes as shown in Figure 4.
STEP 3: Place the Steel Flake on the back of the Shelf Grip, as shown in Figure 5
(Grooves toward the Shelf Grip, to prevent slipping.)
STEP 4: Level the Shelf Grips, and then secure them in position by driving the screws
into the anchors or the stud, as shown in Figure 6.
STEP 5: Insert the Glass Shelf between the Shelf Grips, and then tighten the adjusting
screws, as shown in Figure 7.
Figure 1
Stud
Figure 2Figure 1 Figure 3
Figure 4 Figure 5 Figure 6
Figure 7
8"
Level Line
2700 Oak Industrial Dr. NE
Grand Rapids, MI 49505
800-253-1561
www.kv.com
[e-mail]
©2015 Knape & Vogt. KV and the KV logo are trademarks of Knape & Vogt. 310470/0715