Installation Instructions

ManualsBrandsShelf-Made ManualsShelves & Shelving Units24" W x 6" D Satin Nickel Decorative Glass Shelf Kit

Glass Shelf Kit

89 CHR 31618 | 89 CHR 31824 | 89 WH 10618 | 89 WH 10824

Tools Required (not included):

- Power Drill

- 1/8" Drill Bit

- Screw Driver

- Level

Installation Materials (included):

- Glass Shelf

- Mounting Bracket

- Mounting Hardware

Load Rating:

- 25 lbs when mounted onto studs

Installation:

Step 1: Determine shelf location and mark center hole through the wall mounted

shelf bracket, as shown in Figure 1.

NOTE: Your shelf bracket contains two center holes from which to choose. This lets you

choose a hole to locate the shelf bracket over a wall stud. If unable to do so, hollow wall

fasteners (not included) are recommended.

Step 2: Remove the shelf bracket and drill 1/8" pilot hole.

Step 3: Fasten the shelf bracket through center hole with one of the three screws provided.

Tighten screw, allowing for slight rotation of the shelf bracket, as shown in Figure 2.

Step 4: Place level on top edge of the shelf bracket. Make sure the bracket is level

before marking location for drilling the remaining holes, at the right and left ends of

the shelf bracket.

Step 5: Rotate the bracket to expose marked drill locations. Drill remaining holes. Rotate

the bracket to level position and secure the bracket with remaining screws. Tighten all

screws securely. Do not over tighten.

Step 6: Insert rubber cushion strip into top lip of the shelf bracket. Make sure that the

large ﬂap is toward the wall, as shown in Figure 3.

Step 7: Insert end caps into each end of the shelf bracket. Insert glass shelf all the way

into the bracket slot. Center shelf so it is even on both ends, as shown in Figure 4.

NOTE: If you experience difﬁculty inserting the glass shelf, lightly coat its back edge

with liquid dish soap. Be sure shelf is in contact with the rubber strip.

NOTE: White shelf brackets may be spray painted with acrylic lacquer paint to match or

accent your decor. Follow manufacturer’s recommendations for appropriate drying time.

Figure 1

Center Fastening

Cushion Strip

Location

Figure 2

End Cap/Rectangular

Figure 4Figure 3

2700 Oak Industrial Dr. NE

Grand Rapids, MI 49505

800-253-1561

www.kv.com

customer.service@kv.com