Installation Instructions

Tools Required (Not Included):
- Power Drill
- 3/32” (2.5 mm) Drill Bit
- 3/16” (5 mm) Drill Bit
- Screwdriver
- Tape Measure
- Level
Ledge Shelving
(243-WT, 243-BK)
INSTALLATION INSTRUCTIONS
Installation Materials (Included):
- 1 Small shelf: 10 x 4 x 2” (25.4 x 10.2 x 5.1 cm)
- 1 Medium shelf: 14 x 4 x 3” (35.6 x 10.2 x 7.6 cm)
- 1 Large shelf: 18 x 4 x 4” (45.7 x 10.2 x 10.2 cm)
- 6 Mounting Screws
- 6 Drywall Anchors
INSTALLATION:
STEP 1: Select installation areas and mark the keyhole locations on wall the correct distance apart. Use a level to make sure the ledges will
be straight, as shown in Figure 1.
STEP 2: Pre-drill pilot holes with a 3/32” (2.5 mm) drill bit in the marked locations. If a stud is present, insert and fasten the screw, leaving
a 5/32” (4 mm) gap. If no stud is present, use a 3/16“ (5 mm) drill bit to enlarge the 3/32” (2.5 mm) hole, then insert the anchor
and fasten the screw into the anchor, leaving a 5/32” (4 mm) gap, as shown in Figure 2.
STEP 3: Attach each ledge by placing the keyholes over the screws and applying a light downward force, as shown in Figure 3.
* Ledge shelf can be installed installed with the sides pointing up or down.
x
Figure 1
LEVEL
Figure 2
D
R
Y
W
A
L
L
5/32” (4 mm)
D
R
Y
W
A
L
L
S
T
U
D
5/32” (4 mm)
Figure 3
Back of Shelf
x
REV A 12/07
1-800-367-5726 www.johnsterling.com [e-mail]