Installation Instructions

Mantel Shelf

0149-24HNY | 0149-24WT

Tools Required (not included):

- Power Drill

- 1/8" Drill Bit or 3/16" Drill Bit

- Screwdriver

- Tape Measure

- Level

Installation Materials (included):

- Mantel Shelf

- Mounting Hardware

Load Rating:

- 50 lbs when mounted onto studs

Installation:

STEP 1: Select the desired location for the Mantel Shelf.

STEP 2: Draw a line on the wall using the level in order to determine where the screw

holes will be located. Measure the distance that will be required between the screws

in order to mount the decorative ledge. Mark the positions of the screws in the desired

locations as shown in Figure 1.

NOTE: If the screws are being driven directly into a stud, pre-drill the screw holes

using a 1/8" drill bit and drive the screws without using anchors, leaving 3/8" of each

screw protruding from the surface of the wall, as shown in Figure 2. (Skip to STEP 3)

NOTE: If the screws are being driven into drywall and not into a stud, pre-drill the screw

holes using a 3/16" drill bit. Insert the anchors into the holes and drive the screws,

leaving 3/8" of each screw protruding from the surface of the wall as shown in Figure 3.

STEP 3: Position the keyholes on the back of the Mantel Shelf over the screws. Pull the

Mantel Shelf downward in order to secure it in place, as shown in Figure 4.

STEP 4: If the Mantel Shelf is too loose, or if it does not ﬁt over the screws properly,

remove the Mantel Shelf and adjust the screws accordingly.

Measure Distance

(Back of Shelf)

Figure 1

Figure 4

Figure 2

Stud

3/8"

Wall Surface

Figure 3

3/8"

Wall Surface

2700 Oak Industrial Dr. NE

Grand Rapids, MI 49505

800-253-1561

www.kv.com

customer.service@kv.com