Installation Guide
05152020
MORE MATRIX® QUESTIONS? Call 1-800-355-7429 and select option 2 twice (Se habla español)
Continue installing planks and check that all planks
are fully engaged. If slight gapping is found, fix it with
a tapping block and a scrap of flooring (use the scrap
to protect the floor from the tapping block).
groove
tongue
Place tongue side in the starting corner (work from left
to right).
3.
Use several spacers to maintain a 1/4" expansion gap
along the walls.
4.
Lock the short ends together to complete your first
row. Cut the planks as needed to fit the space.
Start your second row. With a cut-off that is more than
6" long (15cm) or start with a new plank.
5. 6.
Inserting the long side tongue into the groove of the
plank in the first row at a low angle and rotate down.
Second plank, second row: Insert the short end tongue
into the previously installed plank groove.
7. 8.
10.
Align the plank so that the long side tongue tip is
positioned just over the groove lip of the plank in the rst
row. Working from the end seam, at a low angle, insert
the long tongue into the groove of the adjoining plank.
9.
COVER