Installation Guide

FINISHING MOLDING
Reducer molding is used to nish ooring when the adjoining surface is lower than the ooring or when the ooring meets carpet. Position the U track
1.4" (7 mm) between each edge of the ooring. Screw, nail or glue down the track directly to the suboor and then insert the reducing strip into the track.
T-molding is used to nish ooring when two level surfaces meet in doorways or for expansion joints. Install same as above. If your room is more than
26' (8 m) wide you will need to allow for an expansion joint. Same requirement is applied when room is longer than 40' (12 meters).
Landing molding is used to nish ooring on landings or stair edges. Moldings need to be glued and screwed down to the sub-oor for safety and
stability. Color ll should be used to cover counter sunk screws.
To nish the perimeter of the room install quarter round molding using nishing nails. Quarter round molding is nailed directly into the baseboard.
MAINTENANCE AND CLEANING
Our Engineered Hardwood Floors are very easily maintained. No wax, no mess. Simply use a oor cleaner recommended for
hardwood ooring and a specialty terry cloth ooring mop available from ooring retailers.
Step 1: Sweep or vacuum your oor to remove any particles that could scratch your oor.
DO NOT use vacuums with a beater bar or power rotary brush head as they can damage your wood oor.
Step 2: Apply the cleaner directly to the terry cloth ooring mop, not to the oor!
Step 3: Use a back and forth motion with the mop. When the terry cloth becomes soiled, simply replace it with a clean one.
Cleaning the oor with a soiled cover could cause streaking. Many covers are re-usable so depending on the cover either
throw away the cover or wash and dry it as you would any towel.
TIPS AND WARNINGS
Vacuum or sweep regularly.
Remove spills promptly using appropriate oor cleaner and a clean white cloth.
Use felt protectors under heavy pieces of furniture and chairs.
Use protective mats at all exterior entrances.
Spiked heels or shoes in need of repair can severely damage your oor.
Never wet or damp mop your wood oors. Water can cause damage to wood ooring.
Never use oil soaps, wax, liquid or other household products to clean your oor.
The sun’s UV rays can change the color of your oors.
Keep animal nails trimmed.
Protect your oor when using a dolly for moving furniture or appliances.
Never slide or roll heavy furniture or appliances across ooring
Preferable temperature should be approximately 62-73 ˚F (17-23 ˚C) with a relative humidity of 35%-65%. Humidity should never be allowed to drop
below 30% as this may cause gapping.
PISOS DE DISEÑO
POR FAVOR, LEA DETENIDAMENTE TODAS LAS INSTRUCCIONES ANTES DE COMENZAR LA INSTALACIÓN. UNA
INSTALACIÓN INAPROPIADA INVALIDARÁ LA GARANTÍA.
3For reference purposes only if printed or downloaded.