Warranty

Stain Removal Procedures
9
Reminder:
Always follow up with water to remove detergent residue that
may become sticky and cause rapid resoiling.
Procedure A:
Apply solvent to dry towel/cloth. Blot, don’t rub. Repeat
application as above. Blot, don’t rub. Follow with Procedure B.
Procedure B:
Scrape or blot up excess spill. Apply detergent (see “Cleaning
Solutions”), use damp towel. Blot, don’t rub. Apply water with
damp towel. Blot; nish with weighted pad of towels.
Procedure D:
Scrape or blot up excess spill. Apply detergent (see “Cleaning
Solutions”), use damp towel. Blot, don’t rub. Apply ammonia
(see “Cleaning Solutions”), use damp towel. Blot, don’t rub.
Apply white vinegar (undiluted), only after stain is removed.
Apply water rinse with a damp towel. Blot; nish with weighted
pad of towels.
Procedure G:
Scrape or blot up excess spill. Freeze with ice cubes. Shatter
with blunt object such as back of spoon. Remove chips before
they melt.
Procedure L:
Apply solvent remover (non-oily acetone type) to a white
cotton towel and apply to spill. Do not saturate carpet. Pick up
softened material using a clean, white paper towel, push toward
center of the spot (to avoid spreading material). Repeat above,
soften and carefully remove a layer of the material each time.
Haste may spread the stain and/or damage the carpet. Follow
with Procedure B.
Procedure M:
Apply detergent solution (see “Cleaning Solutions”) to white
towel, leave 3-5 minutes. Blot, don’t rub. If stain is removed,
nish with a water rinse, then blot, then apply a pad of weighted
paper towels. If stain is not removed, continue as follows: Apply
hydrogen peroxide solution (see “Cleaning Solutions”), let
stand 2-3 hours under a weighted sheet of plastic wrap. Repeat
application of hydrogen peroxide and allow to dry until removal
is complete. Apply white vinegar only after stain is removed.
Apply water with damp towel. Blot and dry with weighted pad
of paper towels.
Procedure O:
Scrape off excess material. Cover with white cotton towel or
brown paper. Lightly apply warm iron to towel or paper until
material is absorbed. Be sure towel is large enough to cover
the stained area. Never touch the iron directly onto the carpet,
as the ber may melt! Change towel or rotate same towel to a
clean area and repeat until all material is absorbed.
Stain Removal Procedures