Installation Guide

INSTALLATION
Layout of the Plank
a. Carefully place the rst piece of plank at the junction of the chalk lines.
b. Continue to lay the plank, making sure each plank ush against the chalk line and tight against the adjoining plank.
c. Make sure the plank is well seated into the adhesive paying special attention, to the edges. Lay row by row, or in a pyramid fashion as shown below.
Fitting the Border
a. Measure the distance from the last plank in the row to the wall.
b. Mark the plank and cut it against the mark.
c. Lay the plank in place, making sure that the cut edge is against the wall.
Fitting Around Irregular Objects
a. Make a pattern out of heavy paper to t around pipes and other irregularities.
b. Place the pattern on the plank, trace cutting along the trace lines.
IMPORTANT: All ooring must by rolled with a minimum 100 ‐ lb roller after installation. Use a hand roller in areas not
reached with a 100 ‐ lb. roller.
Note: Do not use tape to secure oor protection during construction or renovation. Use ram board or similar to protect the
oor.
7
shawoors.com
For reference purposes only if printed or downloaded. Revision: 04012022