Instruction Manual
REMOTE CONTROL SIDE DRIFTING TRUCK
6+
Printed in China
LED Status Light
Diagonal Forward-Left
On/O
Demo Mode
Dance Demo
Spin Left/Spin RightForward/Reverse
Diagonal Forward-Right
Roll Left Roll Right
Diagonal Reverse-Left
Diagonal Reverse-Right
Note: After the remote control turns on, the indicator light is always on. After connecting the signal of the remote control vehicle, the
indicator light will turn on by pressing any button on the remote control.
If you turn on the remote control and the indicator light is on, the indicator goes out after a long time without matching the remote, but the
remote control is still in operation and needs to be turned o.
1x Side Drifting Truck
Direction 360 Degree Rotation
1x Remote
REMOTE OVERVIEW
DIRECTIONS
WARNING:
CHOKING HAZARD - Small parts.
Not for children under 3 years.
Battery CoverO/On
Battery Cover
The car requires 4 “AA” 1.5V
batteries (not included).
The remote requires 2 “AAA” 1.5V
batteries (not included).
• For indoor use only. Avoid water when operating.
• Do not use people or animals as obstacles.
• Never operate your vehicle on the street or highway.
• Do not run car into furniture objects or hard surfaces as this will
cause damage to both the objects and car.
• Keep fingers, hair and loose clothing away from the tires, gears and
motor while car is switched to “ON”.
• Do not expose to extreme temperatures or moisture
• Do not leave car or transmitter near sources of heat or under direct
sunlight for long periods of time.
• Adult supervision is recommended when operating car.
• Thoroughly inspect products before every use. If the product appears
worn, frayed/splintered, cracked, or broken in any manner,
discontinue use and discard immediately.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Alkaline batteries are recommended. Use only the specified voltage.
• Insert batteries using the correct polarity. Always use, replace, and
recharge (if applicable) batteries under adult supervision.
• Do not charge with non-rechargeable batteries.
• Do not short-circuit the battery supply terminals.
• Do not dispose of batteries in fire, batteries may explode or leak.
• Remove batteries before storing.
• Recycle or dispose of batteries according to federal, state, and local laws.
• Keep these instructions for future reference.
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions:
1)This device may not cause harmful interference, and
2)This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
© 2020 MerchSource, LLC. Irvine, CA 92618. All rights reserved.
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE