Use and Care Manual

10 English
1. Remove Water Tank from main unit.
2. Hold Water Tank upside-down.
3. Remove Water Tank Cap by rotating it in a counter- clockwise direction.
NOTE: In order to minimize potential mineral build-up and prolong the life of your
steamer, distilled or de-mineralized water is recommended.
4. Replace Water Tank Cap by rotating it in a clockwise direction.
NOTE: Place Drain Knob in locked position before replacing Water Tank and
operating unit.
5. Place Water Tank back onto main unit. The sound of water flowing from Water
Tank into Water Reservoir should be audible for a short period of time
NOTE: Water Tank can be removed and refilled at any time during operation –
there is no need to turn unit off or allow any cooling period.
IMPORTANT: Do not attempt to operate unit with an empty Water Tank.
FILLING WATER TANK
CAUTION: Only water should be used in unit – other chemicals or cleaning
agents may cause internal damage. Do not attempt to substitute any other
water tank for the one designed for use with this unit.
CAUTION: IF UNIT TIPS OVER WHILE TURNED ON AND PRODUCING STEAM, IT
WILL CONTINUE TO PRODUCE STEAM. USE CAUTION WHEN PICKING UNIT UP.
31
Français
Votre unité est doté des caractéristiques présentées ci-après. Vérifiez
soigneusement l’emballage pour vous assurer d’avoir toutes les pièces
énumérées ci-dessous. S’il manque des pièces, communiquer (833.800.8669) ou
([e-mail]).
RENSEIGNEMENTS
SUR LE
PRODUIT
7A
CARACTÉRISTIQUES
1
2
3
4
5
6
7
7A
8
9
10
L’injecteur à vapeur
Support de l’injecteur à vapeur et
cintre de façon
Poignée
Tu ya u
Manche télescopique
Bouton de la vapeur
Réservoir d’eau
Bouchon du réservoir (Internal)
Poignée du réservoir d’eau
Hublot de niveau d’eau
Bouchon de vidange
1
2
3
4
5
6
8
7
9
10