QuickSpecs

QuickSpecs
HP EliteDesk 800 G1 Series Business Desktop
Technical Specifications – Hard Disk and Solid State Storage
Worldwide — Version 1.2 — December 3, 2013 Page 30
• DriveLock is supported while in RAID mode. Users can manage the DriveLock password from within F10 Setup. Locked
drives will be displayed as such in the RAID option ROM interface.
• Hard drive information can be viewed within F10 Setup while in RAID mode. Previously, the hard drives will not appear in
Drive Configuration when switching to RAID mode.
• DPS Self-Test can be executed on physical hard drives while in RAID mode.
• The RAID Setup Utility (accessed through CTRL-I) can be protected by the F10 Setup password.
NOTE:
RAID 1 is the only RAID configuration offered via factory configurations. The pre-configured systems:
• Are only available on the SFF and TWR form factors. The USDT and DM form factors do not support RAID as they do not
allow for multiple common storage drives.
• Are complete RAID systems and have both drives installed. If the TWR is configured with three hard disk drives, the third
drive is would be un-partitioned and not part of the RAID array
• Have the necessary Option ROM configuration.
• Are pre-loaded and pre-installed with all required Intel software.
• Include a preinstalled operating system that is mirrored mode out of the box.
HP 1TB 10K rpm SATA 6.0Gb/s 3.5” Hard Disk Drive
Unformatted Capacity
1 TB
Rotational Speed
10,000 rpm
Interface
Serial ATA (6.0 Gb/s)
Synchronous Transfer Rate
(Maximum)
Up to 600 MB/s
Buffer Size
64 MB
Cache
Adaptive
Seek Time (typical reads,
includes controller overhead,
including settling)
Single Track:
1.2 ms
Average:
3.6 ms
Full-Stroke:
9.0 ms
Height (nominal)
0.6 in/1.53 mm
Width (nominal)
Media diameter: 2.5 in/63.6 mm
Physical size: 2.75 in/69.9 mm
Operating Temperature
41° to 131° F (5° to 55° C)