Technical data

6
Econom CL/Econom CL Equipe cattle and horse clipping machine
Aesculap®
¾ Remove the lithium ion battery 39, and push the charged replacement
lithium ion battery GT801 into the battery-operated clipping
machine g, see Fig. 2.
Fig. 2
¾ Secure the lithium ion battery 39 using the battery lock f, see Fig. 3.
Fig. 3
4.5 Handling the cutter head
Lubricating the cutter head
¾ Generously oil the cutter head at the lubrication point a before
shearing each animal, see Fig. A.
¾ Oil spring leaves 10 2 to 3 times daily with 3 to 4 drops of oil, see
Fig. C.
Lubricating the gear wheel
¾ Unlocking and removing the lithium ion battery 39.
¾ Remove both screws 6, see Fig. B.
¾ Then turn the cutter head very slightly (about 15°) counterclockwise
and remove it from the motor shell.
¾ Apply approximately 1 cm of grease on the two opposite points of the
gear wheel 11, see Fig. C.
¾ Carefully place the cutter head on the motor. When re-attaching the
cutter head, ensure that it is turned 15° counterclockwise in such a
way that its lower flange engages with the groove of the motor
housing.
Changing the cutter plate
¾ Unlocking and removing the lithium ion battery 39.
¾ Loosen the locking cap 3 and adjusting screw 4 by
approximately 2 turns, see Fig. A.
¾ Loosen both clamp screws 9, pull off the cutter plate 1 forwards and
remove the upper cutter plate 2, see Fig. D and Fig. E.
¾ Before inserting the upper cutter plate 2, ensure that the oscillating
block 8 is in the intended recess of the oscillator 7, see Fig. E.
¾ Insert the upper cutter plate 2. When doing so, ensure that both tips b
of the oscillator 7 engage precisely in the holes c of the upper cutter
plate 2, see Fig. D.
39
f
39
CAUTION
Damage to the clipping machine or the cutter
head due to incorrect lubrication!
¾ Only oil the cutter head when the machine is
running.
¾ Never immerse the cutter head in liquid of any
kind!
¾ Only use GT604 light lubricating oil.
CAUTION
Damage to the clipping machine or the gear wheel
due to incorrect lubrication!
¾ Use only gear grease GT605.
¾ Lubricate the gear wheel 1 to 2 times during
the shearing season.