Instruction Manual
6+
Printed in China
1-800-374-2744
• Not for children under 6 years of age.
• Do not use people or animals as obstacles.
• Never operate your vehicle in inclement weather, rain, or standing water.
• Keep fingers, hair, and loose clothing away while and before vehicle is in motion.
• Do not expose to extreme temperatures.
• Do not leave the vehicle or remote near sources of heat or under direct sunlight for long periods of time.
• Adult supervision is recommended when operating the vehicle.
• Thoroughly inspect products before every use. If the product appears worn, frayed/splintered, cracked, or
broken in any manner, discontinue use and discard immediately.
• Do not expose to extreme temperatures and moisture.
SAFETY WARNINGS
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Alkaline batteries are recommended. Use only the specified voltage.
• Insert batteries using the correct polarity. Always use, replace, and recharge (if applicable) batteries under
adult supervision.
• Do not short-circuit the battery supply terminals.
• Do not dispose of batteries in fire, batteries may explode or leak.
• Remove batteries before storing.
• Recycle or dispose of batteries according to federal, state, and local laws.
• Keep these instructions for future reference.
1. Turn the power knob on the remote clockwise and flip the power switch on the vehicle to I (ON). The
remote pair light will pulse. It will turn solid when paired.
2. Control the vehicle using the remote-control sticks. The left stick drives forward and backward, and
the right stick spins the vehicle right or left.
3. Split Twister can transform using the 2 large buttons on the top of the remote. To transform, press
either the top left or right button to rotate the body of the vehicle. The vehicle can only transform
180 degrees by pressing one of TWIST buttons. Try the other button if it cannot transform further.
4. Once transformed, try driving or spinning to performs stunts.
BATTERY WARNING
PLAY
WARNING:
CHOKING HAZARD - Small
Parts. Not For Children Under
3 Years.
© 2020 MerchSource, LLC. Irvine, CA 92618. All rights reserved.
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the picture on the manual may dier slightly from the actual product.
RC SPLIT TWISTER
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
CONTENTS AND BATTERY INSTALLATION
Contents
Split Twister Vehicle
Remote Control
Battery Installation
The vehicle requires 4 AA 1.5V batteries (not included) and the remote
requires 4 AA 1.5V batteries (not included).
Use a Phillips head or Cross screwdriver to loosen the screw securing
the battery cover on the bottom of the vehicle and remote. Insert the
batteries, ensuring the correct polarity. Replace the battery cover and
tighten the screw.
Model No.: 1014344