Installation Instructions
MIRROR FEATURES
• Main mirror rotates 360°.
• Front of main mirror features a distortion-free 1x reflection.
• Rear of main mirror features 5x magnification.
• Magnetic mini mirror features 10x magnification.
• Mini mirror can be used separately or magnetically attached towards the top or
bottom of the main mirror.
Tip: For secure attachment in any position, peel the film from the gel pad on the back
of the mini mirror and then press the mini mirror firmly in place. If the gel pad loses
adhesion, rinse it with water and allow it to air-dry before reattaching.
SPASTUDIO™
VANITY SOUND
9–INCH LED MIRROR WITH
BUILT–IN SPEAKERS
SHARPER IMAGE
®
NAME AND LOGOS (INCLUDING
THE 77 LOGO, TOMORROW’S TOMORROW, AND
SPASTUDIO) ARE TRADEMARKS OR REGISTERED
TRADEMARKS. DISTRIBUTED BY AND © 2022
MERCHSOURCE, LLC. IRVINE, CA 92618. ALL RIGHTS
RESERVED.
FOR CUSTOMER SUPPORT, PLEASE CALL
1-800-374-2744.
MODEL NO.: 1015867
Printed in China.
Please read all instructions and warnings prior to
use. Keep this manual as it contains important
information for future reference.
CONGRATULATIONS ON
YOUR PURCHASE OF THE
SPASTUDIO™ VANITY SOUND.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc.


