User Manual

26
Turning the Projector On/Off
Turning the Projector on
Before performing the steps in this section,
connect any equipment that you use with
the projector. (See pages
23, 24 and 25.)
Also connect the power cord to the projec-
tor. (See page
25.)
Press SON/STANDBY on the projector or
AON/STANDBY on the remote control.
• When turning on the projector, you will hear the
system sound. (When “System Sound” is set to
“On”. n page
50)
• When the lamp is warming up, the Adjustment but-
tons blink in a clockwise direction. (When “Guide
LEDs” is set to “On”. n page
48)
• After the projector turns on, the Setup Guide screen
appears. (When “Setup Guide” is set to “On”. n
page
45)
• When System Lock is set, the keycode input box
appears. Enter the right keycode to start projec-
tion. See page
49 for details.
About the Lamp Indicator
• The lamp indicator lights up or blinks, indi-
cating the status of the lamp.
Green: The lamp is ready.
Blinking in green: The lamp is warming up
or shutting down.
Red: The lamp is shut down abnormally
or the lamp should be replaced.
• If the projector is put into the standby mode
and immediately turned on again, the lamp
may take some time to start projection.
On-screen Display (confirmation message)
ON/STANDBY button
1
2
Turning the Power off (Putting
the Projector into Standby Mode)
Press SON/STANDBY on the pro-
jector or AON/STANDBY on the
remote control, then press that but-
ton again while the confirmation
message is displayed, to put the
projector into standby mode.
Unplug the power cord from the AC
outlet after the cooling fan stops.
• When the projector is turned off, the Ad-
justment buttons blink in a counterclock-
wise direction. (When “Guide LEDs” is set
to “On”. n page
48)
• Do not unplug the power cord during projection
or cooling fan operation. This can cause dam-
age due to rise in internal temperature, as the
cooling fan also stops.
Note
Lamp indicator
Info
• English is the factory default language. If you
want to change the on-screen display to another
language, change the language according to
the procedure on page
46.
Info
R
ON/STANDBY
button