Operating instructions

TROUBLESHOOTING
N
N
9402
9-20-04-2
PROBLEM
POSSIBLE CAUSE
POSSIBLE REMEDY
Motor on the planer
will not operate.
Auxiliary hoses not hooked up
to the skid-steer.
Obstruction in hydraulic lines.
Hydraulic motor damaged or
seals blown.
Skid-steer auxiliary valve not
engaged.
Engage Couplers
Remove obstruction and
replace if necessary.
Call Bradco service department
for instructions.
Engage auxiliary valve.
Drum rotates sluggishly. Insufficient hydraulic flow
from the skid-steer.
Damaged quick coupler.
Hydraulic motor damaged or
seals blown.
Oil filter on skid-steer is dirty.
Refer to skid-steer's owners
manual.
Replace if necessary.
Call Bradco service department
for instructions.
Refer to skid-steer's owners
manual.
Leaking Oil. Loose or damaged hydraulic
line.
O-Rings on fittings damaged.
Hydraulic motor damaged or
seals blown.
Fittings loose or damaged.
Cylinder seals damaged.
Tighten or replace.
Replace if necessary.
Call Bradco service department
for instructions.
Tighten or replace.
Replace cylinder seals.
Insufficient power. Insufficient hydraulic flow
from the skid-steer.
Relief valve setting adjusted
too low.
Hydraulic motor damaged or
seals blown.
Oil filter on skid-steer is dirty.
Refer to skid-steer's owners
manual.
Refer to skid-steer's owners
manual.
Call Bradco service department
for instructions.
Refer to skid-steer's owners
manual.
Drum rotates in the wrong
direction.
Hoses from the valve to the
motor incorrectly connected.
Switch hoses at the motor
end.
Excessive vibration during
planing operation.
Picks are worn or broken.
Picks contain flat spots or are
not rotating freely.
Insufficient down force due to
incorrect operating procedure.
Visually inspect the picks and
replace as necessary.
Visually inspect the picks and
replace as necessary.
Refer to the Operating section
of this manual.