Operating instructions

MAINTENANCE & SERVICE

9401

1-15-04

3. Check to be sure the new planetary is

filled with oil. If not, fill with approxi-

mately 2 quarts of Castrol SP 320 gear

oil.

4. Remove the hydraulic motor from the

planetary. Scrape any silicone from the

hydraulic motor and apply new RV 10

silicone to the motor to seal the connec-

tion between the motor and the plan-

etary. Bolt the hydraulic motor onto the

new planetary using the existing hard-

ware.

5. Position the new planetary into the

planer housing and reinstall the .62"

capscrews, flat washers and lock nuts.

TAG AND REMOVE

HYDRAULIC HOSES

FROM MOTOR

REMOVE PLANETARY FROM

PLANER BY UNBOLTING .62" X 2.50"

CAPSCREWS

Check to ensure that the hydraulic motor is in the correct position with the

ports turned up. Torque to specification

6. Reinstall the drum as described in "CHANGING THE DRUM".

7. Re-connect the hydraulic hoses and fittings to the motor.

CHANGING HYDRAULIC MOTOR

1. Position the planer on its side or in such a fashion that the planetary oil will

not leak out when replacing the motor.

2. Tag and disconnect the power and return hoses along with the case drain

hose from the hydraulic motor.

3. Remove the capscrews securing the motor to the planetary.

4. Scrape the mating surface of the planetary, removing all existing silicone, to

prepare it for the new motor.

5. Apply new RV 10 silicone to the motor to seal the connection between the

motor and the planetary. Bolt the new hydraulic motor onto the planetary

using the existing hardware. (Check to ensure that the hydraulic motor is in

the correct position with the ports turned up.) Torque to specification

6. Re-connect the hydraulic hoses and fittings to the motor.